Ip Rsvp Signalling Refresh Interval; Configuration); Ip Rsvp Signalling Refresh Misses (Global Configuration); Ip Rsvp Signalling Refresh Interval (Interface Configuration) - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Command
Function
Command Modes
Command format
Parameter
Description
Example
Command
Function
Command Modes
Command format
Parameter
Description
Default
Configuration
Tips
88 Confidential and Proprietary Information of ZTE CORPORATION
ip rsvp signalling refresh
interval (Interface

Configuration)

This command is used to configure the interval of sending refresh
packets. By executing command no, default interval is reset.
Interface configuration mode
ip rsvp signalling refresh interval <interval-value>
no ip rsvp signalling refresh interval
Parameter
<interval-value>
To configure the interval of MPLS traffic engineering sending re-
fresh packets to 60 milliseconds, execute the following command:
ZXR10(config-if)#ip rsvp signaling refresh interval 60
ip rsvp signalling
refresh misses (Global
Configuration)
This command is used to configure the number of lost refresh pack-
ets. When refresh packets of the specified number get lost, RSVP
will delete corresponding refresh message save state.
Global configuration mode
ip rsvp signalling refresh misses <msg-count>
no ip rsvp signalling refresh misses
Parameter
<msg-count>
The default value is 4.
This command is used to configure the number of lost refresh pack-
ets. When refresh packets of the specified number get lost, RSVP
Description
This is the interval of sending refresh packets,
in milliseconds, 30000 milliseconds (30
seconds) by default, in range of 10-300000.
Description
This is the number of lost refresh packets, in
range of 2-10.