Tunnel Mpls Traffic-Eng Bfd - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Purpose
Command Mode
Syntax
Syntax
Description
Defaults
Example
106 Confidential and Proprietary Information of ZTE CORPORATION
Field
LSP Tunnels Process
RSVP Process
Forwarding
Head
interface
active signalling
attempts
established
Midpoints
Tails

tunnel mpls traffic-eng bfd

Use this command to enable BFD detection on the tunnel of this
device. Use no command to clear this configuration.
Tunnel interface configuration mode
tunnel mpls traffic-eng bfd interval < interval > min_rx <
min_rx > multiplier < multiplier >
no tunnel mpls traffic-eng bfd
Parameter
< interval >
< min_rx >
< multiplier >
Tunnel doesn't support BFD detection.
This example shows how to enable BFD detection of tunnel.
ZXR10(config)#interface tunnel1
ZXR10(config-if)#tunnel mpls traffic-eng bfd interval 300 min_rx 300
multiplier 3
Description
LSP tunnel state
RSVP protocol state
Forwarding state
Statistic information of local tunnel
Number of tunnels in MPLS traffic engineering
Number of tunnels successfully established
or being established
Number of established tunnels
Statistic information of local router serving as
the intermediate node of the tunnel
Statistic information of local router serving as
the end node of the tunnel
Description
the minimum sending interval of specified
BFD control packet
the minimum receiving interval of specified
BFD control packet
the detection multiple of specified BFD control
packet