Tunnel Mpls Traffic-Eng Record-Route - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Command format
Parameter
Description
Default
Configuration
Tips
Example
Purpose
Command Modes
Syntax
Defaults
Example
108 Confidential and Proprietary Information of ZTE CORPORATION
tunnel mpls traffic-eng priority <setup_prirority><holdup-pri
ority>
no tunnel mpls traffic-eng priority
Parameter
<setup_prirority>
<holdup-priority>
The default priority of interface is 7.
V4.8.20 and its later versions support this command.
To configure setup priority 2 and holdup priority 2 for tunnel, ex-
ecute the following commands:
ZXR10(config)#interface tunnel5
ZXR10(config-if)# tunnel mpls traffic-eng priority 2 2
tunnel mpls traffic-eng
record-route
Use this command to enable the tunnel path record function on
the tunnel interface. Disable the function with the no form of this
command.
Interface configuration

tunnel mpls traffic-eng record-route

no tunnel mpls traffic-eng record-reroute
The tunnel path record function is disabled by default.
This example describes how to enable the tunnel path record func-
tion.
ZXR10(config)#interface fei_5/1
ZXR10(config-if)#tunnel mpls traffic-eng record-route
Description
This is setup priority of tunnel.
This is holdup priority of tunnel.