Show Mpls Traffic-Eng Autoroute; Show Mpls Traffic-Eng Interface Detail - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Purpose
Command Modes
Syntax
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
98 Confidential and Proprietary Information of ZTE CORPORATION
show mpls traffic-eng
autoroute
Use this command to show the status and configuration informa-
tion of all tunnels with automatic routes.
All modes except user EXEC

show mpls traffic-eng autoroute

This command is supported after the platform version 4.8.20.
The following contents will be shown after using this command.
(The data below is for reference only):
ZXR10# show mpls traffic-eng autoroute
MPLS TE autorouting enabled
destination 1.1.1.25 has 1 tunnels
TunnelId DestRouterId
NextHop MetricType
1 1.1.1.25
The descriptions of the displayed information are shown below.
Field
TunnelId
Destination
State
NextHop
MetricType
MetricValue
show mpls traffic-eng
interface detail
Use this command to show detailed RSVP information on the in-
terface.
All modes except user EXEC
show mpls traffic-eng interface detail [<interface-name>]
<interface-name>
Information of all interfaces where RSTP traffic engineering is en-
abled are displayed by default.
This command is supported after the platform version 4.8.21.
TunnelState Destination
MetricValue
UP 10.10.10.2
Description
Tunnel ID
TE RouteID of the tunnel destination
Tunnel state
Next hop address of the tunnel
Metric type
Metric value
Interface where RSTP traffic engineering is
enabled
State
relative -1