Mpls Label Range; Mpls Ldp Access-Fec - Zte ZXR10 8900 Series Command Reference Manual

Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
This example describes how to configure mpls mtu on VLAN100
interface mode.
ZXR10(config)#interface vlan100
ZXR10(config-if)#mpls mtu 1452
mpls ip

mpls label range

Use this command to configure a label range for LDP. Restore de-
fault with the no form of this command.
Global configuration
mpls label range <min-label><max-label>
no mpls label range
<min-label>
<max-label>
This example describes how to set the label range as 1000~10000.
ZXR10(config)#mpls label range 1000 10000
show mpls label range

mpls ldp access-fec

Use this command to control LDP's creation of FEC for which des-
tination networks and make sure whether FEC can be created for
routing networks obtained by BGP; this command controls FEC
filter policy. To disable this feature, use the no form of this com-
mand.
Global configuration
mpls ldp access-fec {for <prefix-access-list>| host-route-o
nly | bgp | force}
no mpls ldp access-fec [bgp]
for <prefix-access-li
st>
host-route-only
bgp
force
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
Minimal available label, range: 16~1048575
Maximal available label, range: 16~1048575
Destination network to be filtered, basic ACL:
1~99 and 1000~1499
Creates FEC only for the destination network
(host address) with 32-bit mask
Creates FEC for the specified route network
obtained from BGP
Takes effect immediatedly
13