Clear Flowstat Vpws; L2Protocol-Tunnel - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
60 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10#clear flowstat vpls vfi vfi1
ZXR10#clear flowstat vpls
show mac-table

clear flowstat vpws

Use this command to clear the flow statistics information to which
VPWS corresponds.
Privileged EXEC
clear flowstat vpws vcid <vcid>
clear flowstat vpws vlanid <vlan-id>
<vcid>
<vlan-id>
Clera VPWS flow statistics information by force.
Only ZXR10 6900 and ZXR10 8900 support this command.
This example describes how to clear VPWS flow statistics.
ZXR10#clear flowstat vpws vcid 2
ZXR10#clear flowstat vpws vlanid 2
show mac-table

l2protocol-tunnel

Use this command to configure VPLS layer 2 control message for-
warding policy in vfi.
vfi configuration mode
l2protocol-tunnel { all | all-bridge-multicast | garp | lacp |
lldp | mac-control | port-auth | stp | zdp-ztp }
no l2protocol-tunnel { all | all-bridge-multicast | garp | lacp
| lldp | mac-control | port-auth | stp | zdp-ztp }
Paramter
all | all-bridge-mul
ticast | garp | lacp
| lldp | mac-control
| port-auth | stp |
zdp-ztp
All kinds of messages are not transparently transmitted by default.
Vcid that VPWS corresponds to
Vlan-id that VPWS corresponds to
Description
message type supported by layer 2 message
transparent transmission function