Peer Static-Pw; Pwtype - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Parameters
Description
Defaults
Instructions
Example
Related Command
Purpose

peer static-pw

Use this command to designate other PE addresses in the same
VPLS domain and bind a static PW. Use the no command to delete
remote PE member and release binding with static PW.
VFI configuration mode
at vfi configuration mode:
peer static-pw <peer-ip-address><static-pw-name>[spoke][t
unnel <tunnel-number>]
no peer static-pw <peer-ip-address><static-pw-name>
Parameter
<peer-ip-address>
<static-pw-name>
spoke
<tunne-number>
At Vfi configuration mode, the default peer type is hub.
This command is supported after platform version 4.08.22.
The current implementation project doesn't support VPLS auto-
matic finding mechanism. Therefore all PE addresses must be
designated to belong to the same VPLS domain. This command
uses parameters that vcid and pwtypte command designate to es-
tablish pw with specific PE. Type spoke is used for VPLS gradation
and cross-domain.
The static PW need to be established first and then bind with peer
. One static PW only can bind one time.
configure peer on PE:
ZXR10(config)#vfi vfi1
ZXR10(config-vfi)#peer static-pw 4.4.4.4 static-pw1
vfi
vcid

pwtype

pwtype

Use this command to specify the type of a pseudo-wire established
by the VPLS instance.
Use this command to specify the type of a pseudo-wire in a static
multi-hop pseudo-wire S-PE configuration instance.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 VPLS Configuration
Description
IP address of peer PE, generally router-id is
got.
the name of static PW
if spoke option parameter is taken, pw type is
spoke type or hub type.
1~64 The tunnel number used in establishing
VPLS. The range is 1~64.
63