Show Mpls Interface; Show Mpls Ldp Neighbor - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
42 Confidential and Proprietary Information of ZTE CORPORATION

show mpls interface

Use this command to show the interface on which LDP is enabled.
User EXEC and privileged EXEC
show mpls interface [<interface-name>]
<interface-name>
If there is no parameter after this command , it shows complete
information of the interface where LDP is enabled.
This example describes how to show information about the inter-
face where LDP is enabled.
ZXR10#show mpls interfaces
Interface IP
fei_1/1 Yes(ldp)
fei_1/2 Yes(ldp)
fei_1/3 Yes(ldp)
POS3_2/0 Yes(ldp)
The displayed field descriptions are shown below.
Field
Interface
IP
Tunnel
Operational

show mpls ldp neighbor

Use this command to show information about LDP sessions.
User EXEC and privileged EXEC
show mpls ldp neighbor [<neighbor>|<interface-name>][det
ail]
<neighbor>
<interface-name>
detail
1. This example describes how to show detailed information about
an LDP session.
ZXR10#show mpls ldp neighbor detail
Peer LDP Ident: 172.1.1.1:0; Local LDP Ident 200.1.1.1:0
Interface name
Tunnel Operational
No No
No No
No Yes
No No
Description
Interface name
"Yes" indicates to support MPLS hop-by-hop
label switching
Reserved version to be upgraded
Interface state
IP address of the neighbor, in the dotted
decimal format
Interface name, shows neighbors accepted
from the designated interface
Shows detailed information