Show Ip Rsvp Hello Instance Summary - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Purpose
Command Modes
Syntax
Instructions
Example
112 Confidential and Proprietary Information of ZTE CORPORATION
Type:respond to request I/F: Eth1/1 LSP protectiong:0 Refresh
Interval(msec) Configured:100 Src_instance 0Xa9f07c13 ,
Dst_instance 0X9BBAA407
Description of displayed fields:
Field
neighbor
source
state
type
I/F
LSP protection
Refresh Interval
Configued
Src_instance
Dst_instance
show ip rsvp hello instance
summary
Use this command to show summary information about a Hello
instance.
All modes except user EXEC

show ip rsvp hello instance summary

This command is supported after the platform version 4.6.02.
This example shows summary information about a Hello instance.
ZXR10#show ip rsvp hello instance summary
Clinet I/F Neighbor
Et1/1 11.0.0.1
Se2/1 12.0.0.1
The descriptions of the displayed information are shown below.
Field
Neighbor
State
Description
This is neighbor IP address.
This is the IP address of node sending hello
request packet.
This is communication status. UP indicates
communication is normal and LOST indicates
packets get lost or communication fails to be
established.
ACTIVE indicates node sends request packet
and PASSIVE indicates neighbor sends
request packet.
This is interface type.
This is the number of protected LSPs.
This is the interval of sending request packets.
This is source instance in HELLO object.
This is destination instance in HELLO object.
Type State LostCnt Lsps
PASSIVE UP 0
PASSIVE UP 0
Description
IP address of the neighbor
Communications state: UP indicates
normal communication and LOST indicates
communication is lost or fails
1
1