Mpls Traffic-Eng Tunnels(Global Configuration); Mpls Traffic-Eng Tunnels(Interface Configuration) - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
mpls traffic-eng
tunnels(Global
Configuration)
Use this command to enable MPLS traffic engineering signalling.
Disable the function with the no form of this command.
Global configuration
mpls traffic-eng tunnels
no mpls traffic-eng tunnels
MPLS traffic engineering is not supported by default.
To enable the router to support MPLS traffic engineering, users
must configure this command in the global configuration mode and
enable MPLS traffic engineering on the related interfaces.
This example describes how to enable MPLS TE.
ZXR10(config)#mpls traffic-eng tunnels
mpls traffic-eng
tunnels(Interface
Configuration)
Use this command to enable MPLS traffic engineering signalling
on a interface. Disable the function with the no form of this com-
mand.
Interface configuration
mpls traffic-eng tunnels
no mpls traffic-eng tunnels
The interface does not support MPLS traffic engineering by default.
To enable the interface to support MPLS traffic engineering, users
must enable MPLS traffic engineering in global configuration mode,
and then enable MPLS traffic engineering on the interface. The
interface accepts the MPLS traffic engineering signalling request
and floods its resource information through IGP.
This example describes how to enable MPLS TE signalling on the
interface.
ZXR10(config)#interface fei_3/1
ZXR10config-if)#mpls traffic-eng tunnels
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 MPLS Traffic Engineering Configuration
93