Configuring Ospf For Non-Broadcast Network - Zte ZXR10 GER User Manual

F
I G U R E
Configuration of R1:
ZXR10_R1(config)#router ospf 1
ZXR10_R1(config-router)#network 192.168.2.0 0.0.0.255 area 23
ZXR10_R1(config-router)#network 192.168.1.0 0.0.0.255 area 0
Configuration of R2:
ZXR10_R2(config)#router ospf 1
ZXR10_R2(config-router)#network 192.168.3.0 0.0.0.255 area 24
ZXR10_R2(config-router)#network 192.168.1.0 0.0.0.255 area 0
Related For additional information on OSPF additional configurations,
Information please refer to below procedures.
Configuring OSPF for Non-
Broadcast Network
Purpose This procedure describes how to configure OSPF for non-
broadcast network.
Prerequisites
Steps 1. To configure routers that interconnect to non-broadcast
8 7 O C
S P F O N F I G U R A T I O N
Area 23
192.168.2.1/24
192.168.1.1/24
R1
Router Command Line Interface has been accessed.
OSPF is running on a network as described in above basic
OSPF configuration.
networks, use neighbor <ip-address> [priority <number>]
command in OSPF route mode as shown in Table 237.
T 2 3 7 N
A B L E E I G H B O R
Command Command Mode
Format
neighbor <ip-
address>
OSPF route
[priority
<number>]
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 14 OSPF Configuration
Area 0
192.168.1.2/24
C
O M M A N D
Command Function
This configures neighbor
router on a non-broadcast
network
Area 24
192.168.3.1/24
R2
193