Spanning-Tree Hello-Time; Spanning-Tree Linktype - Zte ZXR10 Command Manual

ZXR10 Command Manual (Ethernet Switch Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
62 Confidential and Proprietary Information of ZTE CORPORATION
show spanning-tree inconsistentports

spanning-tree hello-time

Use this command to set the Hello time (time interval for sending
BPDU packets) of STP. Restore default with the no form of this
command.
Global configuration
spanning-tree hello-time <time>
no spanning-tree hello-time
<time>
The platform version 4.6.02 and upgrade versions support this
command.
This example describes how to set the hello-time to 3 seconds.
ZXR10(config)#spanning-tree hello-time 3
spanning-tree max-hops
spanning-tree forward-delay

spanning-tree linktype

Use this command to set the link type of the port.
Interface configuration
spanning-tree linktype {auto | p2p | share}
auto
p2p
share
The default link type of the port is auto.
� The platform version 4.6.02 and upgrade versions support this
command.
� If the link type of the port is p2p, the fast status change func-
tion can be enabled. If the link type of the port is share, the
status can be changed only after twice of the forward-delay
time.
Hello time, in seconds, in the range of 1~10,
default: 2 seconds
Automatically judges according to the duplex
mode of the port: p2p in full duplex mode
and share in half duplex mode
Forces the link type to p2p
Forces the link type to share