Table of Contents
Advertisement
Step 4
Step 5
Step 6
Configuring the SCOPIA TIP Gateway in SCOPIA Management
This section provides step-by-step procedures for adding and configuring the TIP Gateway.
Adding a gateway in SCOPIA Management
This section describes how to add or modify a gateway to your video network in SCOPIA
Management.
After you add a device, SCOPIA Management connects to it and retrieves additional
information. You can then configure additional settings for your device, such as managing your
bandwidth by using distributed MCUs for a single videoconference.
Before you begin
If you have multiple locations in your network, make sure you have all the locations defined in
SCOPIA Management before adding devices to the network. See
Location.
Procedure
Step 1
Step 2
Step 3
Step 4
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Select the relevant gateway from the Gateways list.
Select the Configure tab (see
Select Advanced Parameters Settings. The Advanced Parameters dialog box appears (see
Figure 5-4 on page
25).
a.
Select h323sigport from the Command ID list.
b.
Enter the port value in the Value field.
c.
Select Save.
d.
Select Close.
•
Adding a gateway in SCOPIA Management .............................................. page 28
•
Configuring the SCOPIA TIP Gateway in SCOPIA Management ........................ page 30
Access the SCOPIA Management administrator portal.
Select the Devices tab.
Select the type of device you are adding or modifying, such as SIP Gateway, TIP Gateway or
SCOPIA Video Gateway from the list in the sidebar.
Do one of the following:
•
To add the device, select Add.
Figure 5-4 on page
25).
Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 28
Adding or Modifying a
Advertisement
Table of Contents
