Configuring Ports On The Scopia Tip Gateway; Limiting Tcp Port Range For H.245 On The Scopia Tip Gateway - RADVision SCOPIA TIP Deployment Manual

Hide thumbs Also See for SCOPIA TIP:

Table of Contents

Configuring Ports on the SCOPIA TIP Gateway

This section provides instructions of how to configure the following ports and port ranges on

the SCOPIA TIP Gateway:

The SCOPIA TIP Gateway designate ports 1024-1174 for H.245 (signaling). H.245 is a control

protocol used for multimedia communications that enables transferring information about the

device capabilities, as well as opening/closing the logical channels that carry media streams.

To provide additional security for your firewall, you can limit this range.

Procedure

Step 1

Step 2

Step 3

Step 4

RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0

•

Limiting TCP Port Range for H.245 on the SCOPIA TIP Gateway ...................... page 25

•

Configuring RTP/RTCP/SRTP Ports on the SCOPIA TIP Gateway ...................... page 26

•

Configuring UDP Port for RAS on the SCOPIA TIP Gateway ............................ page 27

•

Configuring TCP Port for Q.931 on the SCOPIA TIP Gateway .......................... page 27

Select Devices > Devices by Type > Gateways.

Select the relevant gateway from the Gateways list.

Select the Configure tab (see

Figure 5-4

Figure 5-4 on page

25).

Configuring a gateway from SCOPIA Management

Configuring your SCOPIA Solution for Interoperability with Cisco Telepresence | 25

Table of Contents