Operation Example - Mitsubishi Electric Melservo MR-J3-A Instruction Manual

6. DISPLAY AND OPERATION SECTIONS

6.6.2 Operation example

(1) Parameter of 5 or less digits
The following example shows the operation procedure performed after power-on to change the control
mode (Parameter No. PA01) into the speed control mode. Press "MODE" to switch to the basic setting
parameter screen.
To shift to the next parameter, press the "UP" or "DOWN" button.
When changing the parameter No. PA01 setting, change its set value, then switch power off once and
switch it on again to make the new value valid.
Press MODE four times. Select parameter No.8 with UP
The parameter number is displayed.
Press UP or DOWN to change the number.
Press SET twice.
The set value of the specified parameter number flickers.
Press UP twice.
During flickering, the set value can be changed.
Use UP or DOWN .
( 2: Speed control mode)
Press SET to enter.
6 - 11
or DOWN.