Mitsubishi Electric Melservo MR-J3-A Instruction Manual page 381

13. COMMUNICATION FUNCTION
(3) Positioning operation
(a) Operation procedure
Send the command, data No. and data as indicated below to execute positioning operation.
Command : [8][B]
Data No. : [0][0]
Data
Command : [A][0]
Data No. : [1][0]
Data
Command : [A][0]
Data No. : [1][1]
Data
Command : [A][0]
Data No. : [2][0]
Data
Command : [A][0]
Data No. : [2][0]
Data
When LSP/LSN was turned OFF by
external input signal
Make input device valid
Command : [9][2]
Data No. : [0][0]
Data : 00000007
(SON, LSP, LSN turned ON)
Command : [A][0]
Data No. : [4][0]
Data
Command : [8][B]
Data No. : [0][0]
Data
Note. There is a 100ms delay.
Start
: 0002 (positioning operation)
Servo motor speed setting
: Write the speed [r/min] in
hexadecimal.
Acceleration/deceleration time
constant setting
: Write the acceleration
/deceleration time constant
[ms] in hexadecimal.
Movement distance setting
: Write the movement distance
[pulse] in hexadecimal.
Rotation direction selection
: 0000
(forward rotation direction)
0001
(reverse rotation)
When LSP/LSN was turned OFF by external
input signal or automatically turned ON
Command : [9][2]
Data No. : [0][0]
Data
(Note)
Positioning start
: 1EA5
End
: 0000
(Test operation mode cancel)
Make input device valid
: 00000001
(SON turned ON)
13 - 28
Select the positioning operation in
the test operation mode.
Set the operation pattern.
Turn ON Servo-on (SON) to make
the servo amplifier ready.
Start.
Cancel the test operation mode.