Mr-J3-350A4 - Mitsubishi Electric Melservo MR-J3-A Instruction Manual

3. SIGNALS AND WIRING
(3) MR-J3-200A4 MR-J3-350A4
(a) Servo amplifier power supply connectors
Servo amplifier power supply connectors
<Applicable cable example>
Cable finish OD: 4.1mm or less
(b) Termination of the cables
Solid wire: After the sheath has been stripped, the cable can be used as it is.
Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to avoid
a short caused by the loose wires of the core and the adjacent pole. Do not solder the core as
it may cause a contact fault. Alternatively, a bar terminal may be used to put the wires
together.
1.25/1.5
Note 1. Manufacturer: Phoenix Contact
2. Manufacturer: WAGO JAPAN
Cable size
2
[mm ] AWG
16
2/2.5 14
Connector for CNP1
721-207/026-000(Plug)
(WAGO JAPAN)
Connector for CNP2
721-205/026-000(Plug)
(WAGO JAPAN)
Connector for CNP3
721-203/026-000(Plug)
(WAGO JAPAN)
Sheath
Core
8 to 9mm
Bar terminal type
For 1 cable (Note 1)
AI1.5-10BK AI-TWIN2
AI2.5-10BU
3 - 19
Servo amplifier
CNP1
CNP2
CNP3
Crimping tool (Note 2)
For 2 cable
1.5-10BK
Variocrimp 4 206-204