Supplementary Items; Panel Design Example (External Variable Resistor ) - Mitsubishi Electric LE-50PAU Instruction Manual

5. Supplementary items

5.1 Panel design example (external variable resistor )

The following showns a design example of operation panel surface and a connection example relevant input
by using the external variable resistor.
最 小
７
４
１
０
When the [ Auto ] is selected, the tension setting
•
variable resistor is validated.
When the [ Manual ] is selected, the torque setting
variable resistor is validated.
When the switch is turned off, the output is turnede
off immediately. ( Same as when the RC input is
turned off.)
When the [ Start ] switch is selected with [ Auto ] se-
•
lected, the ST input is turned on.
When there is a switch prepared to interlock with
the main reel operation, it is ideal to operate them is
series.
When the ST input is turned off, the calculation of
winding diameter is stopped.
When the [ Reset ] switch is turned of ( start input =
•
off ) with [ Auto ] selected, the winding diameter cal-
culation data is pre-set to the initial diameter.
When the switch is changed from [ Start ] to [ Stop ]
•
with [ Auto ] selected, the stop gain is validated.
When the [ Manual ] is selected, the ST input and RS input are both turned on, which appear to be an
•
output corresponding to the SP input.
In this case, the calculation of winding diameter is cntinued. (refer to page 38.)
< Appendix >
When the stop gain and output OFF mode are not used, it is possible to use the [ Auto / Manual ] switch
•
and [ Start / Reset ] bipolar switch in substitute for neutral OFF switch.
It is also possible to use the [ Auto / Manual ] switch for this purpose, however, note that using the switch
•
may cause the output to change abruptly during [ Auto / Manual ] changeover.
速 度 張 力 クリア
最 大
厚 さ トルク エラー
ＦＮＣ
８ ９
設 定
１
ＦＮＣ
５ ６
▲
２
ＦＮＣ
２ ３ ▼
３
モニタ
初 期 予 備 最 終
実 行
Start
Stop
Reset
Auto
ＯＦＦ
Manual
AUTO
2kΩ
2kΩ
MANUAL
AUTO
50V、0.1A
Keep it short-circuited when
REMOTE is not turned ON/OFF.
35
0 10
Tension setting
(Auto)
0 10
Torque setting
(Manual)
SET
AUTO
SP
MANUAL
SN
Main shaft
Start
ST
Reset
RS
Remote
RC
SN