Mitsubishi Electric Melservo MR-J3-A Instruction Manual page 76

3. SIGNALS AND WIRING
3) When using the flat-blade screwdriver - part 2
1) Insert the screwdriver into the
square window at top of the
connector.
4) Releasing the screwdriver connects the cable.
(5) How to insert the cable into PC4/6-STF-7.62-CRWH or PC4/3-STF-7.62-CRWH connector
Insert the core of the cable into the opening and tighten the screw with a flat-blade screwdriver so that the
cable does not come off. (Tightening torque: 0.5 to 0.6N m(4.425 to 5.31 lb in)) Before inserting the cable
into the opening, make sure that the screw of the terminal is fully loose.
When using a cable of 1.5mm
Servo amplifier
power supply connector
2) Push the screwdriver in the
direction of arrow.
2
or less, two cables may be inserted into one opening.
Cable
Opening
To loosen. To tighten.
3 - 23
3) With the screwdriver pushed, insert the cable in the
direction of arrow. (Insert the cable as far as it will go.)
Flat-blade screwdriver SZS 0.6 3.5
(phoenix contact)