Make A Copy And Delete A Specific Area Of An Original - Oce TDS700 User Manual

Make a copy and delete a specific area of an original

Make a copy and delete a specific area of an original
Introduction
You can make a copy without a specific area of an original with the 'Delete area'
setting. You can use 2 settings to define the dimensions of the delete area and you
can use 2 settings to define the relative position of the delete area on the sheet.
Define the relative position of the delete area with the following settings.
'Y Offset'
■
'X Offset'
■
Define the dimensions of the delete area
'Width'
■
'Length'
■
Attention: When you copy without a specific area, make sure that you copied
all the required information.
How to copy a specific area of an original
Place the original face down and right aligned.
1.
The scanner takes the original.
Define the job settings.
2.
[69]
[69] The icons of 'Y Offset', 'X Offset','Width' and 'Length' setting
Select 'Copy' with the upper-left softkey.
■
The copy job templates appear.
Open a copy job template with a left softkey.
■
The top 5 settings appears.
Scroll to 'Delete area' and open this setting with the left softkey.
■
Define the 'X Offset' with the scroll wheel or numeric keys.
■
Select 'Y Offset' with the left softkey and define the value with the scroll wheel
■
or numeric keys.
Select 'Width' with the left softkey and define the value with the scroll wheel or
■
numeric keys.
Select 'Length' with the left softkey and define the value with the scroll wheel or
■
numeric keys and close the setting.
Define the number of copies if necessary and press the green start key.
3.
120 Chapter 3 Use the Océ TDS700 flexible scanner