Make A Copy Of A Specific Area Of An Original - Oce TCS500 User Manual

Make a copy of a specific area of an original

Make a copy of a specific area of an original
Introduction
You can make a copy of a specific area of an original with the 'Remove strip' setting.
Define the following strips to specify the area.
'Leading'
'Trailing'
'Left'
'Right'
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer queue of
the Océ Queue Manager, a scan-to-file job appears in the selected destination of the
Océ Scan Manager.
Attention: When you remove a strip, make sure that you copied all the required
information.
182 Chapter 7 Use the Océ TCS500 for copy jobs