Bridge Aging-Time - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

4.4.8 bridge aging-time

This command configures the forwarding database address aging timeout in seconds. In an
IVL system, the
Default
Format
Mode
Seconds
Forwarding
Database ID
4.4.8.1 no bridge aging-time
This command sets the forwarding database address aging timeout to 300 seconds. In an
IVL system, the
Format
Mode
Forwarding
Database ID
Port and System Setup Commands
parameter is required.
[fdbid | all]
300
bridge aging-time <10-1,000,000> [fdbid | all]
Global Config
The
<seconds>
1,000,000 seconds.
The forwarding database ID (
warding database's aging timeout is being configured. Use
the option to configure the agetime of all forwarding
all
databases.
parameter is required.
[fdbid | all]
no bridge aging-time [fdbid | all]
Global Config
Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to
configure all forwarding database's agetime.
v1.0, February 2007
parameter must be within the range of 10 to
) indicates which for-
fdbid
4-21