Dhcp Server Commands (Global Config Mode); Ip Dhcp Excluded-Address - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
7.1.15.1 no option
This command removes the options.
Format
Mode

7.2 DHCP Server Commands (Global Config Mode)

This section describes the commands you to configure the DHCP server settings for the
switch. You must be in Global Config mode to execute these commands.

7.2.1 ip dhcp excluded-address

This command specifies the IP addresses that a DHCP server should not assign to DHCP
clients. Low-address and high-address are valid IP addresses; each made up of four
decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
Format
Mode
7.2.1.1 no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
Format
Mode
DHCP Commands
no option <code>
DHCP Pool Config
none
ip dhcp excluded-address <lowaddress> [highad-
dress]
Global Config
no ip dhcp excluded-address <lowaddress> [highad-
dress]
Global Config
v1.0, February 2007
7-9