Table of Contents
Advertisement
14.6.4 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– SAS RAID controller: see section
page 190
– onboard SAS enabling key: see section
enabling key" on page 425
– Heat sinks: see section
– Memory modules: see section
page 253
I
Install all memory modules into their original slots.
– Expansion cards: see section
I
Install all expansion cards into their original slots.
– UFM: install the UFM spacer to the system board and install the UFM see
section
"Installing the UFM" on page 403
– TPM (if applicable): see section
"Installing the power backplane" on page 118
Ê
"Installing the fan box" on page 164
Ê
"Reassembling" on page 63
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility Reference Manual.
Ê Reconnect all external cables.
"Connecting the server to the power source" on page 69
Ê
"Updating or recovering the system board BIOS and iRMC" on page 80
Ê
"Verifying system information backup / restore" on page 83
Ê
"Verifying the system time settings" on page 91
Ê
RX300 S8
"List of used cables" on page
"Installing processor heat sinks" on page 286
"Installing a memory module" on
"Installing expansion cards" on page 182
"Installing the TPM" on page 413
Upgrade and Maintenance Manual
System board and components
465.
"Installing the SAS RAID controller" on
"Installing the onboard SAS
439
Advertisement
Table of Contents
