Table of Contents
Advertisement
Basic hardware procedures
Figure 9: Installing the air duct
Ê Insert the air duct first with the rear side (1).
I
If there is a BBU or FBU installed, follow the procedure that is
described in section
or in section
4.5.2
Closing the server
V
CAUTION!
Before attaching the covers, make sure no unnecessary parts or tools
●
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX300 S8 server must not run while the housing cover
is removed.
For further safety information, please refer to chapter
●
information" on page
64
"Installing the air duct with a BBU" on page 213
"Installing the air duct with an FBU" on page
39.
Upgrade and Maintenance Manual
226.
"Important
RX300 S8
Advertisement
Table of Contents
