Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual page 460

Conversion configurations
Ê If applicable connect the optional front LAN and front VGA cables to the
system board see sections
and "Installing the front VGA connector" on page
Figure 317: Connecting cables
Ê Connect the power cable to the connector of the power cable (1).
Ê Connect the cable C11 to connector X1 of the 4x 2.5-inch HDD
backplane (2) and the connector MLC2 of the SAS controller (3).
Ê Route the cables as shown.
460
"Installing the front LAN connector" on page 376
Upgrade and Maintenance Manual
369.
RX300 S8