Concluding Steps; Removing 2.5-Inch Hdd / Ssd Modules; Preliminary Steps - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX300 S8:

Table of Contents

Hard disk drives / solid state drives

Ê Insert the HDD module into a drive bay and carefully push back as far as it

will go (1).

Ê Close the locking lever to lock the hard disk drive in place (2).

Concluding steps

"Performing a RAID array rebuild" on page 96

Customer Replaceable Unit

Tools: tool-less

Ê If the HDD / SSD module to be removed is combined into a RAID array,

please proceed as follows:

Only remove an HDD module combined in a RAID 0 array if

Removing an operational HDD module will result

in data loss!

Removing an HDD module from a RAID 1 or RAID 5 array

will not result in data loss.

However, the removed drive needs to be replaced

immediately by an HDD module of the same or larger

After replacing the HDD module, RAID rebuild will

be performed as a background process as

described in section

rebuild" on page

Upgrade and Maintenance Manual

Hardware: 5 minutes

"Performing a RAID array