Installing The System Board; Mounting The System Board - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX300 S8:

Table of Contents

System board and components

Ê Slightly lift up the system board by the memory module ejectors and a PCI

slot (1) in order to detach it from the centering bolts (C).

Ê Carefully shift the system board towards the server front until the plug shells

disengage from the cut-outs in the connector panel.

Ê Hold the defective system board by the memory module ejectors and a PCI

slot and at a slight angle lift it out of the chassis.

"Removing the TPM" on page 421

Ê Remove the UFM spacer from the systemboard

14.6.3 Installing the system board

Figure 288: Installing the system board

Ê Hold the new system board by the memory module ejectors and a PCI slot.

– Do not lift or handle the system board by any of its heat sinks!

Upgrade and Maintenance Manual