Mounting The Housing Cover; Mounting The Server In The Rack; Seating The Server On The Rack Rails - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX300 S8:

Table of Contents

Mounting the housing cover

Figure 10: Mounting the housing cover

Ê Open the locking lever on the top cover.

Ê Fit the housing cover on the chassis, aligning it according to the edge guide

marking on the upper server surface.

Ê Lower the housing cover onto the chassis.

Ê Close the locking lever on the housing cover. This will slide the housing

cover shut engaging the locking mechanism.

At least two people are needed to position the server on the rack rails.

(For the Japanese market, please refer to " 安全上のご注意 ".)

For configurations below 32 kg:

At least two people are needed to lift the server

into the rack cabinet.

Upgrade and Maintenance Manual

Basic hardware procedures