In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX300 S8 server must not run while the housing cover
is removed.
For further safety information, please refer to chapter
●
information" on page
4.4.3.1
Removing the housing cover
Figure 6: Removing the housing cover
Ê Open the locking lever (1). This will slide the top cover back disengaging the
locking mechanism (2).
Ê Remove the top cover (3).
RX300 S8
39.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
61