Installing A 3.5-Inch Hdd Module; Concluding Steps; Inch Hdd / Ssd Configurations; Mounting Order For 2.5-Inch Hdds / Ssds - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

7.2.5.3

Installing a 3.5-inch HDD module

"Installing 3.5-inch HDD modules" on page 124
Ê
7.2.5.4

Concluding steps

"Performing a RAID array rebuild" on page 96
Ê
7.3

2.5-inch HDD / SSD configurations

7.3.1

Mounting order for 2.5-inch HDDs / SSDs

Maximum configuration: 16x 2.5-inch HDDs / SSDs
Basic information
– Solid state drives (SSDs) are always equipped before installing hard disk
drives.
– If only one HDD/SSD module is installed, the HDD/SSD module will be
installed in position 1. Empty bays must be equipped with a dummy module.
7.3.1.1 HDD / SSD mounting order for 4x 2.5-inch HDD / SSD
configuration
Figure 38: 2.5-inch HDD / SSD mounting order configuration 2 and 3
7.3.1.2 HDD / SSD naming scheme for 4x 2.5-inch HDD / SSD
configuration
I
The HDD / SSD numbering as listed in the ServerView RAID Manager
differs from the HDD mounting order:
RX300 S8
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
131