Table of Contents
Advertisement
4.6
Connecting the server to the power source
The PRIMERGY RX300 S8 server is equipped with up to two standard power
supplies unit that automatically adjusts to any mains voltage in the range of
100 VAC to 240 VAC or up to two DC hot-plug power supply unit that adjusts
automatically to any power voltage in the range from -40.5 V to -57 V.
Connecting power cords to the mains
V
CAUTION!
The power supply automatically adjusts to any mains voltage in the
range of 100 VAC to 240 VAC. You may only operate the server if its
rated voltage range corresponds to the local mains voltage.
Figure 13: Securing power cord
Ê Connect the power connector (1) to the power supply unit.
Ê Close the cable clamp around the power cord (2) and lock the cable
clamp (3) to secure the power cord.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network or a power outlet of the rack socket strip (see also
"PRIMECENTER Rack System" assembly guide).
RX300 S8
Upgrade and Maintenance Manual
Basic hardware procedures
69
Advertisement
Table of Contents
