Concluding Steps; Replacing The Tape/Rdx Drive In 2.5-Inch Version; Preliminary Steps - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Ê Fasten the tape drive dummy module with 2 screws.
Ê Insert the drive cage into bay 2, for further infomation see
cage and front panel cage" on page 445
Ê If applicable, remove the USB 3.0 interface card as describe in section
"Removing an expansion card" on page 188

12.12.4 Concluding steps

"Installing the fan box" on page 164
Ê
"Installing the front cover" on page 446
Ê
"Reassembling" on page 63
Ê
"Connecting the server to the power source" on page 69
Ê
"Switching on the server" on page 71
Ê
"Verifying and configuring the backup software solution" on page 86
Ê
"Enabling BitLocker functionality" on page 95
Ê
12.13 Replacing the tape/RDX drive in 2.5-inch
version
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver

12.13.1 Preliminary steps

"Disabling BitLocker functionality" on page 73
Ê
"Locating the defective server" on page 51
Ê
"Removing backup and optical disk media" on page 76
Ê
"Verifying and configuring the backup software solution" on page 77
Ê
RX300 S8
Upgrade and Maintenance Manual
Accessible drives
"Installing HDD
Hardware: 10 minutes
339