Installing The Front Panel Module - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Figure 231: Removing the front panel module
Ê Push the locking latches upward (1) to disengage the locking mechanism.
Ê Carefully pull the front panel module out of its bay (2).
V
CAUTION!
Ensure that none of the cables are strained or damaged!
Ê If the front VGA connector has been installed in the defective front panel
module, remove the cable as described in section
connector" on page
Ê If the front LAN connector has been installed in the defective front panel
module, remove the cable as described in section
connector" on page

13.1.1.3 Installing the front panel module

Ê If the front VGA connection is to be installed in the new front panel module,
install the front VGA cable as described in section
connector" on page
Ê If the front LAN connection is to be installed in the new front panel module,
install the front LAN cable as described in section
connector" on page
RX300 S8
374.
374.
369.
376.
Upgrade and Maintenance Manual
Front panel and external connectors
"Removing the front VGA
"Removing the front VGA
"Installing the front VGA
"Installing the front LAN
365