Removing The Bbu Holder From The Air Duct; Concluding Steps - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

9.6.3.3

Removing the BBU holder from the air duct

Figure 107: Removing the BBU holder from the air duct (A)
Ê Lift up the green locking handle on the BBU holder (1) while sliding the BBU
holder in the direction of the arrow as far as it will go (2).
I
After that, the fixation bolts on the air duct will rest in the wide ends of
the keyhole slots on the holder.
Ê Lift the BBU holder from the air duct (3).
9.6.3.4

Concluding steps

"Reassembling" on page 63
Ê
"Connecting the server to the power source" on page 69
Ê
"Switching on the server" on page 71
Ê
Ê If applicable, "Updating RAID controller firmware" on page
"Enabling SVOM boot watchdog functionality" on page 89
Ê
RX300 S8
Upgrade and Maintenance Manual
Expansion cards and backup units
84.
217