Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual page 241

Removing SFP+ transceiver modules
Ê Remove the defective SFP+ transceiver module(s) as described in section
"Removing an SFP+ transceiver module" on page
Installing SFP+ transceiver modules
Ê Unpack the new SFP+ transceiver module.
Ê Verify that the new SFP+ transceiver module is the same type of transceiver
you are replacing.
Ê Install the new SFP+ transceiver module(s) as described in section
"Installing SFP+ transceiver modules" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 96.
RX300 S8
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
Expansion cards and backup units
238.
234.
241