Installing A 3.5-Inch Dummy Module; Concluding Steps - Fujitsu PRIMERGY RX300 S8 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX300 S8:

Table of Contents

Installing a 3.5-inch dummy module

If the removed HDD module is not replaced immediately, always replace

a dummy module into the unused HDD bay to comply with applicable

EMC regulations and satisfy cooling requirements.

Figure 37: Installing a 3.5-inch dummy module

Ê Slide the 3.5-inch dummy module into the drive bay until it locks in place.

"Performing a RAID array rebuild" on page 96

Upgrade and Maintenance Manual

Hard disk drives / solid state drives