When "(Sw)" = Mmnt (Moment), the speaker is rotating. It stops
only when you press the pedal or operate the joystick.
Rotation will occur when the value of the modulation
source is less than 64, and will stop when the value is 64 or
This parameter sets how the rotation speed (slow and fast) is
switched via the modulation source.
When "(Sw)" = Tggl (Toggle), the speed is switched between
slow and fast each time you press the pedal or operate the joy-
Slow/fast will alternate each time the value of the modula-
tion source exceeds 64.
When "(Sw)" = Mmnt (Moment), the speed is usually slow. It
becomes fast only when you press the pedal or operate the joy-
When a value for the modulation source is less than 64,
"slow" speed is selected, and when the value is 64 or higher,
"fast" is selected.
If you wish to control the speaker rotation speed manually, not
switching between Slow and Fast, select the modulation source in
the "ManuSp" ﬁeld. If manual control is not necessary, set this
ﬁeld to Off.
d: Horn Accel, e: Rotor Accel
On a real rotary speaker, the rotation speed is accelerated or decel-
erated gradually after you switch the speed. The "Horn Accel"
parameter sets the speed at which the rotation is accelerated or
f: MicDistance, f: Spread
This is a simulation of stereo microphone settings.
Rotary Speaker - Mic Placement
Rotary Speaker (Top View)
Early reﬂection and delay effects
41: Early Reﬂect
This effect is only the early reﬂection part of a reverberation
sound, and adds presence to the sound. You can select one of
the four decay curves.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Selects the decay curve for the early reﬂection
Sets the time length of early reﬂection
Sets the time taken from the original sound to the ﬁrst early reﬂection
Pre EQ Trim
Sets the input level of EQ applied to the effect sound
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ
Sets the balance between the effect and dry sounds
Selects the modulation source of the effect balance
Sets the modulation amount of the effect balance
This parameter selects the decay curve for the early reﬂection.
Wet / Dry
Wet / Dry
Sharp, Loose, Modulated, Reverse
Dry, 1:99...99:1, Wet
Early Reflections - Type