Er/Delay; 41: Early Reflect (Early Reflections) - Korg MICROX X50 Parameter Manual

When "(Sw)" = Mmnt (Moment), the speaker is rotating. It stops
only when you press the pedal.
Rotation will occur when the value of the modulation
source is less than 64, and will stop when the value is 64 or
greater.
b: (Sw)
This parameter sets how the rotation speed (slow and fast) is
switched via the modulation source.
When "(Sw)" = Tggl (Toggle), the speed is switched between
slow and fast each time you press the pedal.
Slow/fast will alternate each time the value of the modula-
tion source exceeds 64.
When "(Sw)" = Mmnt (Moment), the speed is usually slow. It
becomes fast only when you press the pedal.
When a value for the modulation source is less than 64,
"slow" speed is selected, and when the value is 64 or higher,
"fast" is selected.
c: ManuSp
If you wish to control the speaker rotation speed manually, not
switching between Slow and Fast, select the modulation source in
the "ManuSp" field. If manual control is not necessary, set this
field to Off.
d: Horn Accel, e: Rotor Accel
On a real rotary speaker, the rotation speed is accelerated or decel-
erated gradually after you switch the speed. The "Horn Accel"
parameter sets the speed at which the rotation is accelerated or
decelerated.
f: MicDistance, f: Spread
This is a simulation of stereo microphone settings.
Rotary Speaker - Mic Placement
Mic Spread
Microphone
Mic Distance
Rotary Speaker (Top View)
Microphone
Mic Distance

ER/Delay

Early reflection and delay effects
41: Early Reflect
This effect is only the early reflection part of a reverberation
sound, and adds presence to the sound. You can select one of
the four decay curves.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
EQ Trim
LEQ HEQ
+
Pre Delay
EQ Trim
Right
Type
a
Selects the decay curve for the early reflection
ER Time
b
Sets the time length of early reflection
Pre Delay
c
Sets the time taken from the original sound to the first early reflection
Pre EQ Trim
d
Sets the input level of EQ applied to the effect sound
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ
e
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
f
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
a: Type
This parameter selects the decay curve for the early reflection.
Sharp
Loose
Modulated
Reverse
Dry
ER Time
Pre Delay
(Early Reflections)
Wet / Dry
Early Reflections
Wet / Dry
Sharp, Loose, Modulated, Reverse
☞
10...800ms
0...200ms
0...100
–15.0...+15.0dB
–15.0...+15.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Early Reflections - Type
127