Filter/Dynamic; 00: No Effect; 01: St.amp Sim (Stereo Amp Simulation); 02: St.compressor (Stereo Compressor) - Korg TR Parameter Manual

Music workstation
Hide thumbs Also See for TR:
Table of Contents

Advertisement

Filter/Dynamic

Filter and dynamics control effects

00: No Effect

Select this option when you do not wish to use any effects.
The Insert Effect section outputs unprocessed signals and the
Master Effect section mutes the output.
01: St.Amp Sim
(Stereo Amp Simulation)
This effect simulates the frequency response characteristics of
guitar amplifiers. It is also effective for organ and drum
sounds.
Stereo In - Stereo Out
Left
Right
Amplifier Type
a
Select between three types of guitar amp simula-
tors
W/D (Wet/Dry)
Sets the balance between the effect and dry sounds
(Source)
b
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
02: St.Compressor
(Stereo Compressor)
This effect compresses the input signal to regulate the level
and give a "punchy" effect. It is useful for guitar, piano, and
drum sounds. This is a stereo compressor. You can link left
and right channels, or use each channel separately.
Stereo In - Stereo Out
Left
EQ Trim
LEQ
Envelope Select
EQ Trim
LEQ
Right
Envelope (Envelope Select)
a
Determines whether the left and right channels are linked or used
separately
Sensitivity
b
Sets the sensitivity
Attack
c
Sets the attack level
168
Amp Simulation Filter
Amp Simulation Filter
SS, EL84, 6L6
Dry, 1:99...99:1, Wet
HEQ
Compressor
Output Level
Envelope - Control
Envelope - Control
Output Level
Compressor
HEQ
L/R Mix, L/R Individually
Level (Output Level)
Sets the output level of the compressor
(Source)
d
Selects the modulation source for the compressor output level
(Amount)
Sets the modulation amount of the compressor output level
Pre EQ Trim
e
Sets the EQ input level
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ
f
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
g
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
a: Envelope
This parameter selects whether the left and right channels are
linked to control both signals simultaneously, or whether each
channel is controlled independently.
Wet / Dry
b: Sensitivity, d: Level
The "Sensitivity" parameter sets the sensitivity of the compressor.
If this parameter is set to a higher value, lower level sounds will
be boosted. With a higher Sensitivity, the overall volume level is
higher. To adjust the final volume level, use the "Level" parame-
ter.
Wet / Dry
c: Attack
Off...Tempo
This parameter controls the attack level.
–100...+100
03: St.Limiter
(Stereo Limiter)
The Limiter regulates the input signal level. It is similar to the
Compressor, except that the Limiter compresses only signals
Wet / Dry
that exceed the specified level to lower unnecessary peak sig-
nals. The Limiter applies a peaking-type EQ to the trigger sig-
nal (which controls the degree of the Limiter effect), allowing
you to set any band width to be covered. This effect is a stereo
limiter. You can link left and right channels, or use each chan-
nel individually.
Wet / Dry
Stereo In - Stereo Out
Left
+
1...100
1...100
Right
Compressor - Sensitivity
Level
Wet
Sensitivity=100
Sensitivity=40
Dry
Compressor - Attack
Level
Attack=80
Attack=20
Wet
Dry
Limiter
Side PEQ
Envelope - Control
Trigger Monitor
Envelope - Control
Envelope Select
Limiter
0...100
,
Off...Tempo
–100...+100
0...100
–15.0...+15.0dB
–15.0...+15.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Time
Time
Wet / Dry
Gain Adjust
Gain Adjust
Wet / Dry

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents