04: Mltband Limit (Multiband Limiter) - Korg TR Parameter Manual

Music workstation
Hide thumbs Also See for TR:
Table of Contents

Advertisement

Envelope (Envelope Select) L/R Mix, L Only, R Only, L/R Individually
Selects from linking both channels, controlling only from left channel,
a
only from the right channel, or controlling each channel individually
Ratio
b
Sets the signal compression ratio
Threshold
c
Sets the level above which the compressor is applied
Attack
d
Sets the attack time
Release
e
Sets the release time
Side PEQ Insert
f
Toggles between on/off of the trigger signal's EQ
Trigger Monitor
g
Switches between effect output monitor and trigger signal monitor
EQ (Side PEQ Cutoff)
Sets the EQ center frequency for the trigger signal
Q
h
Sets the EQ bandwidth for the trigger signal
G (Gain)
Sets the EQ gain for the trigger signal
G.Adj (Gain Adjust)
Sets the output gain
(Source)
i
Selects the modulation source for the output gain
(Amount)
Sets the modulation amount of the output gain
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
j
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
a: Envelope
When L/R Mix is selected for this parameter, the left and right
channels are linked to control the Limiter using the mixed signal.
If L Only (or R Only) is selected, the left and right channels are
linked, and the Limiter is controlled via only the left (or right)
channel.
With L/R individually, the left and right channels control the Lim-
iter individually.
b: Ratio, c: Threshold, i: G.Adj
This parameter sets the signal compression "Ratio". Compression
is applied only when the signal level exceeds the "Threshold"
value.
Adjust the output level using the "G.Adj" parameter, since com-
pression causes the entire level to be reduced.
Output Level
Threshold
Louder
Dry
Ratio=1.0 : 1
Level
Ratio=2.0 : 1
Ratio=4.0 : 1
Ratio=Inf : 1
d: Attack, e: Release
These parameters set the attack time and release time. A higher
attack time will cause the compression to be applied more slowly.
1.0:1...50.0:1, Inf:1
–40...0dB
1...100
1...100
Off, On
Off, On
20...12.00kHz
0.5...10.0
–18.0...+18.0dB
–Inf, –38...+24dB
,
Off...Tempo
–63...+63
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Limiter - Threshold / Ratio
Ratio=1.0 : 1
Ratio=2.0 : 1
Ratio=4.0 : 1
Ration=Inf : 1
Input Level
Threshold
Time
Dry
Wet
Wet
Attack
f: Side PEQ Insert, h: EQ, h: Q, h: G
These parameters are used to set the EQ applied to the trigger sig-
nal.
The Limiter determines whether the compression is applied or
not, based on the post-EQ trigger signal. Setting the equalizer
allows you to set the Limiter to respond to any frequency band.
g: Trigger Monitor
Setting this parameter On will cause the trigger signal to be out-
put, instead of the effect sound. Use this parameter to check the
trigger signal with EQ applied.
Usually, set this to Off.
04: Mltband Limit
(Multiband Limiter)
This effect applies the Limiter to the low range, mid range,
and high range of the input signal. You can control dynamics
for each range to adjust the sound pressure of the low range,
mid range, and high range in a different way from the EQ.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Band-Pass Filters
Low
Envelope - Control
Mid
Low Offset
+
Envelope - Control
High
Mid Offset
Envelope - Control
High Offset
Right
Ratio
a
Sets the signal compression ratio
Threshold
b
Sets the level above which the compressor is applied
Attack
c
Sets the attack time
Release
d
Sets the release time
Low Offset
e
Gain of the low-range trigger signal
Mid Offset
f
Gain of the mid-range trigger signal
High Offset
g
Gain of the high-range trigger signal
G.Adj (Gain Adjust)
Sets the output gain
(Source)
h
Selects the modulation source for the output gain
(Amount)
Sets the modulation amount of the output gain
Limiter - Attack / Release
Threshold
Ratio=Inf : 1
Attack=1
Release=1
Ratio=Inf : 1
Attack=100
Release=100
Release
Wet / Dry
Limiter
Limiter
Gain Adjust
Limiter
Wet / Dry
1.0:1...50.0:1, Inf:1
Fx:03
–40...0dB
Fx:03
1...100
Fx:03
1...100
Fx:03
–40...0dB
–40...0dB
–40...0dB
–Inf, –38...+24dB
Fx:03,
Off...Tempo
–63...+63
169

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents