Installing A 3.5-Inch Hdd Dummy Module; Concluding Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

7.3.5.3

Installing a 3.5-inch HDD dummy module

V
CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 97: Installing a 3.5-inch HDD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.3.5.4

Concluding steps

"Installing accessible drive and HDD bay covers" on page 69
Ê
TX2540 M1
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
173