7.3.4.3
Installing a 3.5-inch HDD dummy module
V
CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 57: Installing a 3.5-inch HDD dummy module
Ê Slide the dummy module into the drive bay until it locks in place.
7.3.4.4
Concluding steps
Ê If applicable,
"Installing the HDD bay cover" on page 64
TX1330 M1
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
139
Need help?
Do you have a question about the Server PRIMERGY TX1330 M1 and is the answer not in the manual?
Questions and answers