Table of Contents
Advertisement
Digital AVC Instruction Manual
2. Installation
Receiving Inspection
Unpack and inspect all items for obvious signs of damage. Immediately advise Teledyne Hastings and
the carrier of any suspected damage. In the unlikely event that items need to be returned, first obtain a
Return Material Authorization (RMA) number from our Customer Service Department at 1-800-950-2468 (757-
723-6531).
Cable Removal/Installation
The cable shipped with the HPM 4/5/6 (Part # CB-HPM 4/5/6) is attached to the instrument using a locking-
type connector. This cable will need to be removed when replacing the instrument's battery or when replacing
a damaged cable. Refer to the following figures and instructions below:
2.2.1.
Removal
1. Remove the instrument from the rubber boot (easier to reach the cable lock).
a. Open the stand and push the bottom portion of the instrument out of the boot.
b. Pull the rest of the instrument out of the boot.
c. Be careful not to bend the cable connector plug.
2. Pull the cable through the boot opening until you can easily grasp the Connector Plug.
3. Twist the coupling ring counterclockwise about 120 degrees until you feel it unlock and hit the stop.
4. Pull the connector plug out of the pin socket and boot opening.
5. Leave off the cable assembly for maintenance or discard it if damaged.
2.2.2.
Installation
1. Remove the rubber boot if not already off (see 2.2.1)
2. Thread the new cable through the boot opening and onto the pin socket
3. Align the detent and push the connector plug until it bottoms out (all the way in).
4. Push the coupling ring over the pin socket connection (you may need to twist the coupling ring slightly
counterclockwise to do this).
5. Twist the coupling ring clockwise about 120 degrees until it locks.
6. Push the instrument back into the boot.
EAR99 Technology Subject to Restrictions Contained on the Cover Page
Page 9 of 17
Advertisement
Table of Contents
