Connect Power - Teledyne T3EL15030 P Series User Manual

Connect Power

T3EL15030xP
The
For each line voltage, the rear panel voltage selector settings are to be set according
to the table below:
Please connect the power carefully by following the steps below:
1. Check the input power
Ensure that the AC line power to be connected to the instrument meets the
requirements in Table 1.
2. Check the voltage selector at the rear panel
Make certain that the voltage selector setting located at the rear panel of the
instrument matches the actual input voltage.
3. Check the fuse
When the instrument leaves the factory, the specified fuse is installed. Please check
to verify the fuse matches the actual input voltage according to the "Input Power
Requirements" on the rear panel of the instrument.
4. Connect the power
Connect the instrument to the AC power source using the power cord provided
in the accessories. Then press the button
WARNING
Before switching on the input power supply voltage, please
disconnect the power supply before setting the voltage selector to the
appropriate position.
WARNING
To avoid electric shock, please ensure that the instrument is correctly
grounded.
10
electronic load supports a variety of AC line power input values.
AC Power Input
110 Vac ± 10%
50/60Hz
220 Vac ± 10%
50/60Hz
Voltage Selector
110V
220V
to turn on the electronic load.