Cli Command Syntax; Ironstack Cli Commands - Dell PowerConnect B-FCXs Configuration Manual

5
Managing your IronStack

CLI command syntax

CLI syntax that refers to stack units must contain all of the following parameters:
•
•
•

IronStack CLI commands

CLI commands specific to stacking are listed in
command. For more information about CLI commands and syntax conventions, refer to
"Getting Familiar with Management
TABLE 23
Command
copy flash flash
clear stack ipc
cx4-10g
kill console
priority
rconsole
reload stack unit
show chassis
show flash
show memory
show module
show running-config
show stack
show stack detail
show stack flash
show stack ipc
show stack neighbors
show stack resource
show stack rel-ipc stats
show stack rel-ipc stats unit #
show stack stack-port
124
<stack-unit>/<slotnum>/<portnum>
<stack-unit> - If the device is operating as a standalone, the stack-unit will be 0 or 1. Stack IDs
can be 0 or any number from 1 through 8.
<slotnum> - Refers to a specific group of ports on each device.
<portnum>- A valid port number. You can list all of the ports individually, use the keyword to to
specify ranges of ports, or a combination of both. To apply the configuration to all ports on the
device, use the keyword all in
Stacking CLI commands
Table 23, with a link to the description for each
Applications".
Description location...
"Copying the flash image to a stack unit from the Active Controller"
page 126
"Troubleshooting an unsuccessful stack build"
"Changing PowerConnect B-Series FCX-S and CX4 ports from 16 Gbps to 10
Gbps" on page 110
"Configuring TACACS/TACACS+ for devices in a Dell IronStack"
"Changing the priority of a stack unit"
"Logging in through the console port"
"Reloading a stack unit" on page 126
"Displaying chassis information"
"Displaying flash information"
"Displaying memory information"
"Displaying stack module information"
"Displaying running configuration information"
"Displaying stack information"
"Displaying stack information"
"Displaying stack flash information"
"Troubleshooting an unsuccessful stack build"
"Displaying stack neighbors" on page 142
"Displaying stack information"
"Displaying stack rel-IPC statistics"
"Displaying stack rel-IPC statistics for a specific stack unit"
"Displaying stack port information"
on page 152
on page 123
on page 118
on page 133
on page 131
on page 132
on page 134
on page 143
on page 135
on page 135
on page 137
on page 152
on page 135
on page 138
on page 141
on page 143
PowerConnect B-Series FCX Configuration Guide
Chapter 1,
on
on page 1165
53-1002266-01