Using Snmp To Upgrade Software - Dell PowerConnect B-FCXs Configuration Manual

3

Using SNMP to upgrade software

PowerConnect#copy flash console startup-config.backup
ver ver 7.2.00aT7f1!
stack unit 1
module 1 FCX-24-port-management-module
module 2 FCX-cx4-2-port-16g-module
module 3 FCX-xfp-2-port-16g-module
priority 80
stack-port 1/2/1 1/2/2
stack unit 2
module 1 FCX-48-port-management-module
module 2 FCX-cx4-2-port-16g-module
module 3 FCX-xfp-2-port-16g-module
stack-port 2/2/1 2/2/2
stack enable
!
!
!
!
vlan 1 name DEFAULT-VLAN by port
no spanning-tree
metro-rings 1
metro-ring 1
master
ring-interfaces
enable
!
vlan 10 by port
mac-vlan-permit ethe 1/1/5 to 1/1/6 ethe 2/1/5 to 2/1/6
vlan 20 by port
untagged ethe 1/1/7 to 1/1/8
no spanning-tree
pvlan type primary
pvlan mapping 40 ethe 1/1/8
pvlan mapping 30 ethe 1/1/7
!
vlan 30 by port
untagged ethe 1/1/9 to 1/1/10
no spanning-tree
pvlan type community
!
...
some lines omitted for brevity...
Syntax: copy flash console <filename>
For <filename>, enter the name of a file stored in flash memory.
Using SNMP to upgrade software
You can use a third-party SNMP management application to upgrade software on a PowerConnect
device.
NOTE
Dell recommends that you make a backup copy of the startup-config file before you upgrade the
software. If you need to run an older release, you will need to use the backup copy of the
startup-config file.
62
ethernet 1/1/2 ethernet 1/1/3
no spanning-tree !
PowerConnect B-Series FCX Configuration Guide
53-1002266-01