Ipv6 Traceroute; Ipv6 Management Commands - Dell PowerConnect B-FCXs Configuration Manual

IPv6 traceroute

The traceroute command allows you to trace a path from the Dell PowerConnect device to an IPv6
host.
The CLI displays trace route information for each hop as soon as the information is received.
Traceroute requests display all responses to a minimum TTL of 1 second and a maximum TTL of 30
seconds. In addition, if there are multiple equal-cost routes to the destination, the Dell
PowerConnect device displays up to three responses.
For example, to trace the path from the Dell PowerConnect device to a host with an IPv6 address of
3301:23dd:349e:a384::34, enter the following command.
PowerConnect#traceroute ipv6 3301:23dd:349e:a384::34
Syntax: traceroute ipv6 <ipv6-address>
The <ipv6-address> parameter specifies the address of a host. You must specify this address in
hexadecimal using 16-bit values between colons as documented in RFC 2373.

IPv6 management commands

The following management CLI commands are available in Dell PowerConnect devices that support
IPv6:
•
•
•
•
•
•
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
show ipv6 traffic
clear ipv6 traffic
show ipv6 TCP
show ipv6 access-list
show ipv6 neighbor
clear ipv6 neighbor
IPv6 management commands
7
205