Dell PowerConnect B-FCXs Configuration Manual page 77

Syntax: [no] link-config gig copper autoneg-control down-shift ethernet <port> [ethernet <port>] |
Specify the <port> variable in the following formats:
•
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both.
You can enable port speed down-shift on one or two ports at a time.
To disable port speed down-shift after it has been enabled, enter the no form of the command.
Configuring port speed down-shift and auto-negotiation for a range of ports
Port speed down-shift and auto-negotiation can be configured for an entire range of ports with a
single command.
For example, to configure down-shift on ports 0/1/1 to 0/1/10 and 0/1/15 to 0/1/20 on the
device, enter the following.
PowerConnect(config)# link-config gig copper autoneg-control down-shift ethernet
0/1/1 to 0/1/10 ethernet 0/1/15 to 0/1/20
To configure down-shift on ports 5 to 13 and 17 to 19 on a compact switch, enter the following.
PowerConnect(config)# link-config gig copper autoneg-control down-shift ethernet
5 to 13 ethernet 17 to 19
Syntax: [no] link-config gig copper autoneg-control [down-shift | 100m-auto | 10m-auto] ethernet
The <port-list> is the list of ports to which the command will be applied.
For <port-list>, specify the ports in the following formats:
•
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.
The output from the show run command for this configuration will resemble the following.
PowerConnect# show run
Current configuration:
!
ver 7.2.00a
!
module 1 FCX-48-port-management-module
module 2 FCX-cx4-2-port-16G-module
!
link-config gig copper autoneg-control down-shift ethernet 0/1/1 to 0/1/10
ethernet 0/1/15 to 0/1/20
!
!
ip address 10.44.9.11 255.255.255.0
ip default-gateway 10.44.9.1
!
end
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
to <port>...
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
<port-list>
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
Configuring basic port parameters
2
35