Power-On Desktop/Csl - StorageTek 9840 Product Manual

Power-On Desktop/CSL

Use the instructions below to power-on the 9840 desktop drive or the CSL:
Note: Ensure the female end of the power cord is plugged into the drive/CSL.
1. Attach the male end of the power cord to a power outlet.
2. Press the power switch on the 9840 Tape Drive/CSL.
3
4
Note: The desktop drive and CSL shown above use a SCSI interface to the host.
3. Verify that the 9840 Tape Drive powers on.
Note: A steady asterisk on the operator panel indicates a successful IPL completion, the
drive is online, but not loaded with a cartridge.
4. Proceed to "Configure the Drive" on page
95741
1
4
2
3
C53821
3-53.
Sixth Edition
1. Desktop drive
2. CSL
3. Power switch
4. Power cord
Desktop Units
3-25